For a single-point load using two sling legs, which value represents the maximum variation?

Unlock all questions

This demo includes only 20 questions. Upgrade to access hundreds of questions, flashcards, exam simulations, and disable ads.

Full question bankExam simulationsFlashcards
From $24.99Unlock all

Prepare for the Sling Load Inspector Certification Course Test. Study effectively with flashcards and multiple choice questions, each accompanied by hints and explanations. Get ready to ace your exam!

Multiple Choice

For a single-point load using two sling legs, which value represents the maximum variation?

Explanation:
When lifting a single-point load with two sling legs, the goal is to keep the load level and have both legs share the load fairly equally. The maximum allowed variation between the two leg lengths is six inches. This limit helps keep the pull angles close to equal and the load line near the load’s center of gravity, which minimizes tilting, asymmetric loading, and excessive side load on the lifting point. If one leg is much longer than the other, the load will tilt toward that leg, increasing tension on one side and risking instability or swinging during the lift. To verify, measure each leg from the apex connection to the load point; if the difference exceeds six inches, adjust by reconfiguring the slings so the variation is within six inches. The other values would either be impractical for maintaining stability or would allow too much tilt.

When lifting a single-point load with two sling legs, the goal is to keep the load level and have both legs share the load fairly equally. The maximum allowed variation between the two leg lengths is six inches. This limit helps keep the pull angles close to equal and the load line near the load’s center of gravity, which minimizes tilting, asymmetric loading, and excessive side load on the lifting point.

If one leg is much longer than the other, the load will tilt toward that leg, increasing tension on one side and risking instability or swinging during the lift. To verify, measure each leg from the apex connection to the load point; if the difference exceeds six inches, adjust by reconfiguring the slings so the variation is within six inches. The other values would either be impractical for maintaining stability or would allow too much tilt.

More Multiple Choice Questions
Subscribe

Get the latest from Examzify

You can unsubscribe at any time. Read our privacy policy